Trevi XF 800 Mode D'emploi Et Branchement page 7

ENGLISH
19
20
21
22
23
TRANSPORTATION
To carry the device can use the handle which is mounted the display (9).
POWER
This unit works with rechargeable lead-acid 12V, 4,5Ah and DC power supply 15V, 2A (included).
When the battery and 'being phased out or the device does not turn on, plug the power cord supplied in the battery charging socket(17) on the device
and plug the adapter into a power outlet to recharge .
Lamp status LED charging(17):
- RED LED flashing light: indicating that the battery is' being charged.
- LED light RED fixed: charging process completed, the battery and 'charge.
Caution:
- The battery is charged only when the main switch ON/OFF (18) is ON position.
- Do not connect the appliance to sockets with a voltage other than that indicated.
- Do not use power supplies other than the one supplied with voltage or current, and other than that indicated.
BASIC FUNCTIONS
POWER ON/OFF
Press the main switch ON / OFF (18) to position ON to turn the power.
Press the main switch ON / OFF (18) to position OFF to switch off.
STAND-BY
You can switch the system to standby mode using the button
Caution:
- The stand-by function is activated only if the ON/OFF switch(18) is ON.
- We remember leaving the unit in stand-by function the battery discharges faster than using the ON/OFF(18).
MODE SETTING FUNCTION
To change the mode function, press more 'times the MODE key (8) on the unit or press the button (25) on the remote control to select RADIO (di-
splay comapre frequency), BLUETOOTH (the display BLUE), USB (only if the USB socket (10) is connected to a memory, the display shows for a
few seconds USB), SD (SD only if the outlet (10) is connected to a memory, the display shows SD for a few seconds), AUX (the display shows U).
ADJUSTING THE VOLUME
1. Turn the volume VOL. (1) to increase or decrease the overall volume of playback, or use the buttons (23) and (29) on the remote control.
2. Turn the MIC VOL (16) to adjust the volume level signal inputs MICROPHONE (11). The adjustment acts on the two inputs simultaneously
PRE-EQUALIZER
This unit has the pre-equalization audio. Press the SOUND button (27) on the remote control to select a setting that best suits the sound reproduction
in progress. The pre-equalization are active and can be selected only in the USB and SD function.
Remote control
19. Power ON/OFF
20. REPEAT Key (single repeat, repeat all)
24
21. 0-9 Keys
22. Play/pause(all the sound will off when pause)
25
23. Volume -
24. MUTE
26
25. MODE Key (Shift AUX/USB/SD mode)
27
26. RECORD Key
27. Sound mode key(several sound modes circulated)
28. Previous song
21
29. Volume +
28
30. Next song
29
Installing the Batteries
30
Remove the battery cover from the Remote Control and put 2xAAA size batteries inside the compartment.
The diagram inside the Battery Compartment shows the correct way to install the batteries.
(19) on the remote. Press it again to turn it back on
7
XF 800