Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE AND INSPECTION
WARNING:
1. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
WARNING:
2. Inspecting the carbon brushes (Fig. 17)
The motor employs carbon brushes which
are consumable parts. Replace the carbon
brush with a new one when it becomes worn
to its wear limit. Always keep carbon
brushes clean and ensure that they slide
freely within the brush holders.
CAUTION: Using this router with a carbon brush which is worn in excess of the wear
limit will damage the motor.
NOTE: Use metabo HPT carbon brush No. 43 indicated in Fig. 17.
3. Replacing carbon brushes
Remove the brush caps with a slotted
screwdriver. The carbon brushes can then
be easily removed. (Fig. 18)
4. Service and repairs
All quality power tools will eventually
require servicing or replacement of parts
because of wear from normal use. To assure
that only authorized replacement parts will
be used, all service and repairs must be
performed by a metabo HPT AUTHORIZED
SERVICE CENTER, ONLY.
5. Service parts list
CAUTION: Repair, modification and inspection of metabo HPT Power Tools must be carried
out by a metabo HPT Authorized Service Center.
This Parts List will be helpful if presented with the tool to the metabo HPT Authorized Service
Center when requesting repair or other maintenance. In the operation and maintenance
of power tools, the safety regulations and standards prescribed in each country must
be observed.
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this router with loosened screws is extremely dangerous.
English
Wear limit
43
No. of carbon
Fig. 17
Brush Cap
Slotted-head
Screwdriver
Fig. 18
15
Publicité
Table des Matières
