Publicité
Les langues disponibles
Les langues disponibles
To fi nish installing the wall plate and before positioning the
TV, we advise you to fold your bracket right back against the
wall, in order to adjust the tilt of the mounting plate by +/- 5°.
For this, unscrew the four nuts on either side of the spirit level slightly.
This operation will allow you to check that your installation is plumb
before moving onto the next step.
installation of fi xed arms
Cover a stable, fl at surface with a soft cloth.
•
Place the screen of your appliance on the soft cloth.
•
Locate the threaded mount points on the back of the screen.
•
!
Determine the correct screw length by carefully inserting a match or toothpick and
marking the depth of the mount point. Refer also to the operating instructions for your screen.
M5x30
Depending on your screen model and the depth of the mount point, we advise you to use the following
combinations of screw fi xings (screws + washers + 1, 2 or 3 spacers):
M4 x 12 metal
screws
or
M4x12 ou M5x12
M5 x 12 metal
screws
M4x12 ou M5x12
M4/M5 washers
M4x12 ou M5x12
M8-4 spacers
(if needed)
18
V.2.0
M6x12 ou M8x16
installation of fixed arms
M6x35 ou M8x40
Once the bracket is fi xed to the wall, place the two
plastic covers on either side of the wall plate to
hide the metal part.
M4x30 ou M5x30
M4 x 30 metal
M6 x 12 metal
screws
screws
or
or
M5 x 30 metal
M8 x 16 metal
screws
screws
M4/M5 washers
No washers
M8-4 spacers
and/or
M8-4 spacers
M8-8 spacers
(if needed)
and/or
M8-12 spacers
installation of fi xed arms
Bas
Bottom
Before inserting the screws, don't forget to leave suffi cient space behind your screen to
•
accommodate the connectors of your multimedia devices (scart cable, HDMI cable...) by
using the different models of spacers.
The use of angled or jointed cables is sometimes necessary to avoid damaging the connections
•
to your screen.
M6 x 35 metal
screws
If your screen has a curved back or a recessed mount point, a spacer must be used.
or
Choose the spacer which is the closest to the depth of the recess in order to hold the bracket as close
M8 x 40 metal
to the screen as possible.
screws
or
Place the spacer between the fi xed arm and the screen. Use the washers provided with the M4-M5
M8 x 45 metal
screws for optimal stability.
screws
No washers
M8-4 spacers
and/or
M8-8 spacers
and/or
M8-12 spacers
8
7
V.2.0
V.2.0
installation of fi xed arms
X
TV
TV
Haut
Top
Unscrew
the
two
retaining screws (one
screw per fi xed arm),
without removing them
completely,
before
installing
the
arms
onto the wall plate.
19
V.2.0
installation of fixed arms
Publicité
