Leica CF 22 Notice D'utilisation page 37

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 43
Problem:
Flash photos are overexposed.
• Make sure that the flash unit is correctly insert-
ed in the camera's accessory shoe!
• Set the flash unit to
• The distance to the subject may not be less than
10% of the maximum range of the flash light!
• Select a lower ISO sensitivity on the camera
and/or a higher aperture value!
• Have you set an exposure correction value
for flash photos on the camera?
Problem:
Flash photos are underexposed.
• Make sure that the flash unit is correctly insert-
ed in the camera's accessory shoe!
• Set the flash unit to the operating mode
• The distance to the subject may not exceed
10 % of the maximum range of the flash light!!
• Set a higher ISO sensitivity on the camera
and/or a lower aperture value!
• Have you set an exposure correction value
for flash photos on the camera?
TTL
mode!
TTL
!
Problem:
Flash photos are not properly illuminated at
the edges.
• Attach the wide-angle diffuser!
• Use longer focal lengths for your shots.
Problem:
Range is not indicated in the LC Display.
• Make sure that the flash unit is correctly insert-
ed in the camera's accessory shoe!
• Data exchange has not taken place between
the camera and the flash unit. Press the
camera release button.
• Your camera type is not transmitting com-
plete data for the aperture or ISO values to
the flash unit.
Unsuccessful attempts to identify faults
• Turn off flash unit (4) with the main switch,
wait briefly and turn it back on again.
• Reset flash unit settings (see p. 28).
If in the flash unit still fails to function despite
following the above instructions, then you
should contact an authorised dealer.
36

Publicité

Table des Matières
loading

Table des Matières