Publicité
1. Remove fi xture components and parts pack(s) . Check
that all parts are included. See Page 2.
from housing asssembly (4) by gently pressing tabs on
bottom of diffuser and lift from housing. See Fig 2.
Note: Turn off power at circuit breaker box!
Fixture is suitable for wall or ceiling installation.
2. Remove Mounting Plate (1) from Housing (4) by removing
the two fi nials (5) with phillips screwdriver. Mounting
Plate is installed from factory for installation to round or
octagon or horizontal rectangle junction boxes- See Fig 2. For
installation to vertical rectangle junction boxes- Mounting Plate
(1) will need to be adjusted. Remove two 1/2" screws (2) from
Mounting Plate (1). Rotate backplate (1) 90 degrees and
reinstall (2) 1/2" screws (2)- See Fig. 3
3. With the power turned off at circuit breaker box, position
Mounting Plate (1) near the junction box and feed supply wires
through center hole, position with installed Screws aligned
horizontally (after mounting) and threads facing outward.
Secure using 1" Screws (7) provided.
See Fig. 3 or Fig. 4
Assistance may be required to support fi xture during installation.
WIRING AND FIXTURE OPERATION CAUTION:
Connect fi xture to supply wires rated for at least 90°C (194°
F).
4. With the power turned off, hold the housing assembly (4)
fi rmly and connect the ground wire from the fi xture to the
bare copper ground wire from the junction box using a
Wirenut (3). (If house wiring does not include a ground wire,
consult your local electrical code for approved grounding
methods). See Fig. 1.
FOR PROPER CONNECTION, PLACE WIRENUT OVER
WIRES, TWIST CLOCKWISE UNTIL TIGHT.
5. Use Wirenuts (3) to connect black fi xture wire to the black
power supply wire and white fi xture wire to the white power
supply wire. See Fig. 1.
6. Tuck wires into junction box.
7. Position the
Housing Assembly
protruding from the Mounting Plate (1) and secure fi xture with
Finials (5).
8. Install diffuser (6) by inserting bottom tabs into the housing.
See Fig 5. Rotate diffuser into housing and
snap small tabs into housing. See Fig 6.
9. Turn on electricity at fuse or circuit breaker box and verify
success of installation.
STEP BY STEP GUIDE
Installation Instructions - ENGLISH
Remove diffuser (6)
(4) over the screws
Page 4
Trouble Shooting Guide
If this fi xture fails to operate properly, use the guide
the guide below to diagnose and correct the problem.
Verify that fixture is wired properly.
Verify that fixture is grounded correctly.
The line voltage at the fixture is correct.
This LED light provides low maintenance service with no bulbs
to change. Clean surfaces with mild soap and water. Do not
use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
Publicité
