Berger 359320 Manuel D'utilisation page 14

EN
Air circulation and high temperatures:
The ventilation slots on the back of the unit must always remain free. Please do not place
newspapers or blankets on or over the TV set. If the TV set is placed in a cupboard or on a shelf,
make sure that there is at least 2 cm of free space at the top and sides for air circulation. Like any
electronic device, your TV set requires air for cooling when it is in operation. If the air circulation
is obstructed, this may cause a fi re. Only place the TV set with the stand on a level, stable, hori-
zontal surface. The front of the TV set should not protrude, especially when it is installed in or on
top of furniture. Set up the TV set in such a way that it is not exposed to direct sunlight or any
additional is exposed to heat from radiators. Avoid metal parts, needles, paper clips, liquids, wax
or similar objects getting inside the device through the ventilation slots in the rear panel. This will
cause short circuits in the device and may result in a fi re. If anything does get inside the machine,
unplug the machine immediately and contact your service representative to check.
Repairs and accessories:
Never remove the rear panel of the TV set yourself. Only allow authorised TV technicians to per-
form repair and service work.
Cleaning:
Clean the TV set, the display and the remote control only with a damp, soft and clean cloth wit-
hout any abrasive or harsh cleaning agents.
Note on the LED display:
The TV set with LED display which you have purchased meets the highest quality standards and
has been checked for pixel errors. Despite the utmost care in the manufacture of the displays, it
cannot be 100% ruled out for technological reasons that pixels may have defects.
SCOPE OF SUPPLY
1. LED TV set
2. 230 volt power supply
3. remote control
4. 12 volt connection cable
5. operating instructions
6. Stand
26
POSITION AND FUNCTION OF THE CONTROL BUTTONS
FB19BT2, FB22BT2, FB24BT2 and FB27BT2
1 Input, Menu
2 Channel selection
3 Volume
4 On / Off
Position Key labelling
1 INPUT / MENU
2 CH+ / -
3
VOL+ / -
4
The on/off switch is located at the back next to the control buttons.
EN
Function
• Selection of input signal: Antenna, Cable,
Satellite, Media, AV, PC, YpbPr and HDMI
• Opening or exiting a menu
• Selecting the TV channels, press this key
to select the channels or to select the
upper or lower menu in the OSD menu
• Increase or decrease the volume
• Adjusting the selected menu items in the
OSD menu
• Power button in standby mode
27