Dometic VacuSealer VS1000 Notice D'utilisation page 17

VacuSealer VS1000
Operation Problem
12 Vg opera- The device is not
tion being supplied with
voltage.
The device does
not work.
Operation is
delayed compared
to when using with
230 Vw.
The fuse of the
12 V plug has
blown.
The device vac-
uum-packs but
doesn't seal.
EN
Possible cause Remedy
The device is Connect the device to the
not connected 12 V power supply cor-
to the 12 V rectly.
power supply
Only use the cable
properly.
included in the scope of
supply.
– Switch on the vehicle igni-
tion before you use the
device.
Delayed operation is nor-
mal.
Check the 12 V Only use the cable
connection included in the scope of
cable. The 12 V supply.
connection
cable is
equipped with a
fuse inside.
The 12 V volt- Switch on the vehicle igni-
age supply may tion before you use the
vary depending device.
on the state of
the battery.
Several con- Only connect one con-
sumer units are sumer unit to the 12 V con-
connected to nection.
the 12 V con-
nection.
Troubleshooting
17