BullFrog Kicker BF400 Manuel D'utilisation page 25

FCC - Federal Communications Commission Interference Statement
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation
Caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a
residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications However,
there is no guarantee that interference will not occur in a particular installation If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body
IC - Industry Canada Statement
This device complies with ISED's licence-exempt RSSs Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation
Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body
Le présent appareil est conforme aux CNR d' ISED applicables aux appareils radio exempts de licence
L'exploitation est autorisée aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement
non contrôlé Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de
rayonnement et votre corps
CE
Hereby, Stillwater Designs and Audio, Inc declares that this BF400 is in compliance with the essential requirements and
other relevant provisions of:
EU COMPLIANCE INFORMATION
Conforms to European Union Low Voltage Directive 2014/35/EU;
European Union EMC Directive 2014/30/EU;
European Union Restriction of Hazardous Substances Recast (RoHS2) Directive 2011/65/EU;
European Union WEEE Directive 2012/19/EU;
European Union Eco-Design Directive 2009/125/EC;
European Union Registration, Evaluation, Authorization and Restriction of Chemicals (REACH)
Directive 2006/121/EC;
European Union Radio Equipment Directive (RED) 2014/53/EU
43BF400-D-20161229
FCC ID: A8TBM64S2
IC ID: 12246A-BM64S2
© 2016 Stillwater Designs
24