6.
Select your Wireless network in the list, please look careful and select the right one.
"Wireless Lan" can also be referred as "SSID" in some router manuals or on the bottom of the router.
7.
Behind the SSID you can also find your type of encryption, in this particular case the Camera discovered: Network type
"infra" Encryption "WEP".
8. If there is no encryption, select "none" and click "Submit". (Figure 6.4).
9. If there is encryption, please input the share key (password), then click "Submit". (Figure 6.5).
10. Wait about 30 seconds, the camera will reboot, after full reboot unplug the network cable. You might have to login to
the
Camera
again
Jul 2013
with
the
IP
Camera
Tool
to
continue
Figure 6.3
25
with
the
next
steps.
IPV38 / IPV38WE