Firmware Upgrade - Ebode IPV38 Guide Utilisateur

NOTE: You can find the Subnet Mask, Gateway, DNS Server from your router, or check the local connection status of your
computer, to get all the parameters. Normally two DNS servers are optional. Please go to step 3.7.3 (CMD) if you do not
know how to find this information.
Http Port: LAN port assigned for the equipment, default is 80. We strongly recommend you to set another port number
like 81, 82, 83 etc. for your camera since most internet providers will block port 80.
User: Default administrator username is: admin (please make sure all are lowercase letters).
Password: Default password is bank, i.e. no password.
NOTE: When the prompt "subnet doesn't match, double chick to change!" appears, please set the IP Address, Subnet
Mask, Gateway, DNS Server once again, or enable Obtain IP from DHCP server.
For Network Settings please go to step 1.9

1.7.4 Firmware Upgrade

Enter the correct User and Password to upgrade system Firmware and Web UI. Please upgrade system firmware first and
then upgrade Web UI or it may damage the camera.（Figure 2.4).
Figure 2.4
Please download the firmware package for the correct type of your camera before you upgrade.
Follow the upgrade document carefully to upgrade. Please see readme first before you upgrade.
Visit our website for new firmware releases in case of trouble www.ebodeelectronics.eu
CAUTION: You should not upgrade the firmware unnecessarily. It is possible to damage the camera if a mistake is made
during the upgrade. If your camera works well with the current firmware, we strongly recommend that you don't upgrade
it.
NOTE: When doing an upgrade, remember you must keep the power on, and it's best to use wired mode, connected via
the network cable.
Jul 2013 14 IPV38 / IPV38WE