VDO KIMAX Notice De Montage Et D'utilisation page 49

Installation and operating instructions
To adjust only specific values, press the
key until the desired value is display-
ed.
Setting the LO value
• Press the key.
• Use the keys to set the current axle load.
(Example: display reads
tonnes)
• To save the LO value, press the
oder
• If you do not want to save the value, press the
key.
HI
3
appears on the display.
Setting the HI value
• Load the vehicle or trailer/semitrailer and de-
termine the axle load using calibrated scales.
If the calibration procedure was interrup-
ted (e.g. through disconnection of the
battery), repeat the above steps, starting
at heading Starting calibration mode.
055
at axle load 5.5
key.
© Siemens VDO Trading GmbH
• Press the key.
• With the keys, set the current axle load.
(Example: display reads
tonnes)
• To save the HI value, press the
oder
• If you do not want to save the value, press the
key.
A1
3
appears on the display.
Setting alarm value A1
• Press the key.
• With the key, set the desired alarm value.
(Example: display reads
11.0 tonnes)
• To save the A1 value, press the
oder
• If you do not want to save the value, press the
key.
A2
3
now appears on the display.
Calibration
100
at axle load 10.0
key.
110
at alarm value
key.
23