Aux-In (8); Headphone; Replacing Batteries; Basic Specifications - THOMSON RT250 Mode D'emploi

Aux-In (8)

Play Audio Via MP3 Player (AUX-IN)
1. Using a 3.5 mm jack lead (not provided), connect one end to the MP3 Player and the other end
to the Audio-In jack (8) on this unit.
2. Operate your MP3 player as directed by your manufacturer

Headphone (9)

You can plug stereo headphones (not included) equipped with a 3.5 mm jack and impedance of 32
ohms or greater into the headphone jack (9). When using headphones, the speakers are automatically
disconnected.
WARNING: USING HEADPHONES
Please avoid extended play at a very high volume when using headphones. If you
experience ringing in your ears, reduce the volume or shut off your unit. Excessive volume
can result in damage to your eardrums and partial or permanent hearing impairment. If your
ears hurt, please contact a doctor.

Replacing Batteries

• Insert 4 x 1.5V, UM-2 "C" size, R14 batteries. Check the polarity (+ and – at ends of the battery) and
follow the instructions on the diagram near the battery compartment. Close the compartment door.
NOTE: Please make sure to properly dispose of batteries (see your local regulations).

Basic Specifications:

Output: 0.5 W
230V AC ~ 50 Hz
4 bands: Frequency range
FM 87.5 ~ 108 MHz
SW 2.3 ~ 22 MHz
MW 522 ~ 1620KHz
LW 144 ~ 290KHz
1.5V DC x 4, UM-2, "C" size , R14
- EN 5 -