Publicité
Les langues disponibles
Les langues disponibles
Instructions on commissioning of the Ethernet interface
To use opti-check in your network, you must assign the device a unique IP address.
The default factory configuration is:
1. If your network has a DHCP server, the IP address will request from that server.
You do not need any further manual adjustments.
2. If a valid IP address can not be determined within 15 seconds, the following
network configuration is used:
Default IP address: 192.168.0.250 (Subnet mask: 255.255.255.0)
My device is not located in the selection list after launching the
Application Suite ?
1. Check that the power cable of opti-check is connected correctly.
2. Make sure that your PC and opti-check are connected in the same network.
3. Check the network settings of your PC, especially the IP address and
subnet mask. Contact your administrator possibly.
4. Make sure that each IP address is unique in your network!
EN
Industrial Ethernet
The models OC538 [D/E] XX / OC539 [C/D/E] XX integrate Industrial Ethernet
(PROFINET / EtherNet/IP
Activation:
Detailed instructions can be found in technical documentation.
18 18 EN
™
).
Device ➞ Device settings... ➞ Process interface
Publicité
