Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people.
•
Use the original packaging if the device is to be transported.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4.
Mounting the device
•
Install the device in a well ventilated room.
•
Do not put the device directly on carpet or wood or any other flammable floor covering. Install the
device at least 50 cm high from a flammable floor.
•
Never stand directly below the device when it is being mounted, removed or serviced.
•
Make sure there is no flammable material within a 3 m radius of the device.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
Fuse Replacement
Only fit or replace a fuse when the device is unplugged from the mains.
Replace a blown fuse with a fuse of the same type and rating (see Technical Specifications):
1.
Remove the fuse holder using a flat-head screwdriver.
2.
Remove the old fuse and install a new one.
3.
Put back the fuse holder.
5.
Use
1.
Make sure the power switch is set to OFF.
2.
Make sure the device is connected to an earthed socket.
3.
Use the appropriate liquid (see "Technical Specifications") to add in the tank on top of the unit.
4.
Insert the power cable into the mentioned power supply.
5.
Set the power switch on the backside of the device to ON. The device starts operating.
6.
The LED on the controller will light up.
7.
Push the red button on the controller and the device will start spurting
smoke.
8.
Set the power switch to OFF to stop the device.
Warning
•
Never operate the device when the tank is open.
•
Make sure that the tank never runs empty during operation. If it does run empty, immediately
switch off the fog machine via the power switch and allow it to cool down. You can check the liquid
level on the side pane of the device.
6.
Cleaning and maintenance
•
Disconnect the device from the mains prior to maintenance activities.
•
All screws should be tightened and free of corrosion.
•
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in
mounting supports, do not change the location of the connections.
•
Moving mechanic parts must not show any signs of wear and tear.
•
The electric power supply cables must not show any damage. Have a qualified technician maintain
the device.
•
Clean the heat proof tube with a mixture of 20% vinegar and 80% distilled water after every 40
hours of use.
•
Wipe the device case regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
•
There are no user-serviceable parts.
•
Contact your dealer for spare parts if necessary.
V. 01 – 12/04/2012
VDL900SM
4
©Velleman nv
Publicité
Table des Matières
