Publicité
Blue and green blinks simultaneously: in an active Creative
ShareMe connection.
Red and fl ashes once: powering off the headset.
Red and blinks slowly: low battery level, charge the headset
soonest.
6.
Red: charging headset. This goes off when headset is fully
Left earcup indicator
charged.
Connector / Port
7.
Use the supplied USB cable for charging the headset via a
Micro-USB charging
laptop or computer.
connector
8.
Use the supplied audio cable for a wired connection to non-
Audio Input connector
wireless devices or when battery power runs out. Connect the
smaller 2.5mm diameter plug to the headset (align the triangular-
shaped connector properly) and the larger 3.5mm diameter plug
to your audio device.
9.
Noise suppression microphone for crystal clear communications
Invisible Microphone
and environmental sensing microphones for ANC processing.
10.
Tap your NFC-enabled mobile devices here to establish
NFC (Near Field
Bluetooth pairing and connection. Tap again to end connection.
Communication) pad
Function
Technical Specifi cations:
•
Driver: 40mm Neodymium magnet
•
Frequency Response: 15Hz ~ 22kHz
•
Impedance: 32ohms
•
Sensitivity (1kHz): 105dB/mW
•
Noise Reduction Level: Up to 17dB (85%)
•
Wireless Technology: Bluetooth v3.0
•
Bluetooth Profi les: A2DP, AVRCP, HSP, HFP (HD Voice ready)
•
Audio Codec: aptX, AAC, FastStream, mSBC, SBC
•
Content Protection: SCMS-T
•
Operating Frequency: 2402 ~ 2480 MHz
•
Operating Range: Up to 10m / 33ft
•
Power Supply: Rechargeable Lithium Ion battery, 3.7V, 620mAh
•
Charge via USB: 5VDC, 500mA
•
Charge / Play / Talk Time: 2 hours / 15 hours* / 21 hours*
•
Net Weight: 292g / 10.3oz
FastStream allows low latency wireless bi-directional audio streaming and voice communication with
Creative BT-W1 Bluetooth USB transceiver. HD Voice requires supported handsets and mobile networks
* Without ANC
Publicité
