DRAIN HOSE KIT: FITTING INSTRUCTIONS
To avoid having to empty the water container
after each drying cycle, the water normally
collected during the drying cycle can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks).Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe system should be located adjacent to the
tumble dryer.
The kit is composed: 1 hose, 1 straight
hose connector, 1 pipe clip and 1 plastic tie.
WARNING!
Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Kit as Follows:
1 . U n s c r e w
a n d
remove the 3 screws,
at the rear of the
machine, retaining the
worktop trim.
2. Remove the rear
worktop trim and the
worktop surface by
carefully sliding it
towards the rear of the
machine.
3. The waste water
container is situated at
the right-hand side of
the machine (viewed
from the rear). A grey
hose connects to the
bridge above the water
container. Using pliers,
r e m o v e t h e p i p e
retaining clip from the
bridge.
4. Pull the hose off the
bridge connection.
5. Attach the hose from
the kit, using the
connector and pipe
clips supplied, to the
hose removed from the
bridge connection.
EN
6
6. Take off the water
container cover from
the rear of the machine
by removing the two
screws and unclipping
the cover.
7. Break off the tab on
the side of the cover
and replace the cover
on the machine, refit
the screws. You should
now have revealed a
hole in the back of the
cabinet next to the
Cover.
8. Feed the drain hose
through the hole in the
cabinet.
9. Locate the grey pipe
in the cutout of the tray
and secure the pipe
assembly to the bridge
with the plastic tie.
10. Carefully slide the
worktop back into
position ensuring that
the hose is not trapped
a n d r e p l a c e t h e
worktop rear trim with
the 3 screws.
11. Connect the new
drain hose to the waste
water pipe. Make sure
that the new hose does
not kink when pushing
the tumble dryer into
position. Ensure that
the guidelines, as
shown, are followed
when routing the new
external hose.
12. Connect to the
m a i n s e l e c t r i c i t y
supply.
13. After emptying the
waste water container
switch the machine ON
(and press the 'START'
button on electronic
models) to commence
w i t h t h e d r y i n g
program.