NEPTUN classic NCUWL-O 3x10 Notice D'emploi page 10

- GB -
Installation and connection
B, C
• The unit can be placed submerged or dry.
• For installation above water: Ensure a safety distance of at least 50 cm from combustible material.
Do not cover the unit!
• Install the transformer at a minimum safety distance of 2 m from the water.
How to proceed: 8.
0.
1. Position the unit such that it does not present a hazard to anyone and the lamps are tilted as desired.
2. Connect the plug of the spotlight connection cable to the socket on the transformer and hand-tighten the union nut.
Start-up
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
• Electrical units and installations with a rated voltage of U > 12 V AC or U >30 V DC located in the water:
Isolate the units and installations (switch off and disconnect from the power supply) before reaching into the
water.
• Isolate the unit before starting any work.
• Secure the unit to prevent unintentional switching on.
Switching on: Insert the power plug of the transformer into the socket.
• Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
Remedy of faults
Malfunction
Lamp does not light up
Luminosity decreases
Water inside the spotlight housing
S
10
GA Beleuchtungsset NCUWL-O 3x10.10 10 GA Beleuchtungsset NCUWL-O 3x10.10 10
Cause
Power supply interrupted
Bulb defective
Lamp glass soiled
The brightness of the bulb reduces as the
operating time increases
Seal defective
Fire hazard:
Remedy
Check power supply
Replace bulb
Clean
Replace bulb
Check sealing rings and replace, if necessary
20.12.2013 11:08:22 20.12.2013 11:07:03