HQ Power VDPC148 Mode D'emploi page 8

ERASING ALL PROGRAMS
1) Press and hold the record button.
2) Press the flash buttons 1, 4, 2 and 3 in sequence while holding the record button. All LEDs will flash, indicating all
programs stored in the memory have been erased.
CLEARING A SCENE OR SCENES
1) Record enable.
2) Record a scene or scenes.
3) lf you are not satisfied with the scene or scenes, you can press the rec clear button while pressing and
holding down the record button. All LEDs will flash, indicating the scenes have been cleared.
DELETING A STEP OR STEPS
1) Record enable.
2) Press the step button to scroll to the step you wish to delete.
3) Press the delete button when you reach to the step you wish to delete, all LEDs will flash briefly indicating the
deletion of the step.
4) Continue steps 2 and 3 until all unwanted steps have been deleted.
5) Press the rec exit button while pressing and holding down the record button, the scene LED goes out, indicating
your leaving the exit mode.
INSERTING A STEP OR STEPS
1) Record a scene or the scenes you wish to insert.
2) Make sure you're in a CHNS◄►SCENE. Enter the edit mode.
3) Press the step button to scroll to the step which you wish to insert. You can read the step from the display.
4) Press the insert button to insert the step you've created before. All LEDs will flash indicating the step has been
inserted.
5) Exit the edit mode.
EXAMPLE: Insert a step with channels 1-12 fully on at time in between steps 4 and 5 of program 35.
1) Record enable
2) Push the channel sliders 1-12 to the max. setting to record the scene as a step.
3) Press the mode select button to select CHNS◄►SCENE mode.
4) Press the page button until the page 2 LED lights.
5) Press flash button 35 while holding down the edit button. The corresponding scene LED will light.
6) Press the step button to scroll to step 4.
7) Press the insert button to insert the scene you've created before.
MODIFY A STEP OR STEPS
1) Enter the edit mode.
2) Press the step button to scroll to the step you wish to modify.
3) Press and hold the up button if you want to raise the intensity. If you want to lower the intensity, press and hold
the down button.
4) While holding down the up or down button, press the flash button corresponding to the DMX channel of the scene
you wish to modify until you reach the desired intensity value read from the display. Press the flash
buttons until you are satisfied with the new scene.
5) Repeat steps 2, 3 and 4 until all steps have been modified.
6) Exit the edit mode.
VDPC148 8 VELLEMAN