Select Program; Start Program - FINO FINOFORNO S Mode D'emploi

7.5 Select program

Pic. 35: LED Prog.

7.6 Start program

7.7 Start program automatically
Pic. 36: Select program
20
1. Press⇨key until the LED below the
"Prog" display is on.
2. Select program (1-9) with the Plus and
Minus keys.
• Start program with Start/Stop key.
The program starts and the furnace start
heating.
• During the program cycle the operation
display shows the furnace temperature
respectively the remaining holding time.
• The day/time display shows the time of
completion of the program.
• Using the⇨key you can display the set
temperature/holding time.
At any time the program can be aborted with
the Start/Stop key.
After the Start/Stop key has been pressed again
the program will start from the beginning.
The furnace can be started automatically with an
integrated timer in a way that the heating program
is finished at a pre-selected completion time. With
the timer you can determine the completion time.
1. Select program (» subsection select program).
Pic. 34: Timer activated
Pic. 35: Select week day
Pic. 36: Select hour
Pic. 37: Select minute
Pic. 38: Casting time
Pic. 39: Check start time
ENU
2. Activate timer with key.
The green LED below the key lights up.
The yellow LED "week day" blinks.
3. Select week day (Mo = 1, Tue = 2, ...) with Plus
and Minus keys (here example Wednesday).
4. Press⇨Key. The yellow LED "Time" blinks.
5. Select time (hours) with Plus and Minus keys
(here example six o'clock).
6. Press⇨Key.
7. Select time (minutes) with Plus and Minus
keys (here example 30 minutes).
8. Press⇨key to finish entry of the completion
time.
After the casting time has been entered the start
time can be checked by pressing the Start/Stop
key.
NOTE! By pressing the key again
the integrated timer is deactivated.
This makes the immediate manual start
of the selected program possible.
21