Storing The Power Cord - Wella Professionals Contura HS60 Mode D'emploi

Contura.book Seite 28 Freitag, 6. Januar 2012 1:01 13
– Insert the mains adapter 8 in a
– Place the charging unit 2 on a
– Place the appliance in the charging unit. It posi-
tions itself and starts charging. The red charging
indicator 1 is always on when the appliance is
charging. Make sure the On/Off switch 4 is in the
0 position when charging.
To maintain the charging capacity of the recharge-
able battery we recommend occasionally running
the battery down until the motor stops.
28
power socket.
flat surface.

2.2 Storing the power cord

If you do not need the full length
of the power cord, part of it can
be stored in the cable storage
compartment 9.
1. Pull out the mains plug.
2. Turn the charging unit upside
down.
3. Wind the excess cable round the holder in the
base, then run the cable through the small recess
in the housing to the outside.