Publicité
Les langues disponibles
Les langues disponibles
WORKING
Mod. SL TC – Glass (dis. 11)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function de-
sired by touching the relative key.
If the electrical power supply to the product
SLTC is cut, 15 seconds are needed for sel-
fdiagnostics after the functions are restored.
In the meanwhile, its operation may be incor-
rect.
The products are endowed with an electronic
device which allows the automatic switching
off after 4 hours working from the last ope-
ration.
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suc-
tion speeds control, when the air capacity ex-
ceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equip-
ped with a timer device that automatically
switches the suction speed from 4th to 3rd
speed, after 5 minutes operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter
panel. It can be removed by pushing its spe-
cial handle toward the back-side of the co-
oker hood and turning the filter downwards
so to unfasten it from its slot (Fig. 4).
To insert the filter just perform the opposite
operation.
After 30 hours working (model), the push
button control panel will signal the satura-
tion of the grease filter by lighting all the
buttons. Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig. 12) needs
to be periodically replaced. The coal filter
can be removed by removing the grease filter
first (Fig. 4), and by pulling its special plastic
tongue until it is unfastened from its slot.
Re-insert the coal filter by operating in the
opposite way. The coal filter needs replacing
depending on the use, but however every six
months at least.
* To clean the appliance itself tepid water
and neutral detergent are recommended,
while abrasive products should be avoided.
For steel appliances specialized detergents
are recommended (please follow the instruc-
tions indicated o the product itself to obtain
the desired results).
LED BAR REPLACEMENT
To remove the led bar , it is recommended to
remove the steel bar as shown in Fig. 6 and
7, then disengage the led bar by acting on
the specific fastening springs.
Replace the led bar with one of the same
characteristics.
Refit the steel bar.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevi-
ce agent or a similarly qualified person in
order to avoid a hazard.
7
.
Publicité
