Pairing A Second Bluetooth Device; The Sava 1001 As A Receiver (Rx); Audio Outputs; Switching On - Vogel's SAVA 1001 Mode D'emploi

The sound from your TV will now be played over your headphones
or speaker.
4.2.4

Pairing a second Bluetooth device

The SAVA 1001 allows you to pair two Bluetooth receivers
simultaneously. After pairing the first Bluetooth device, put the
second device in pairing mode.
Slide the multifunctional switch (2) all the way to the right (BT).
The LED will now start to blink red/blue, indicating that the SAVA
1001 is ready for pairing. Now slide the multifunctional switch back
to the centre position for optical connection (OPT), or all the way
to the left for analogue connection (AUX).
The pairing with the first Bluetooth device will be momentarily
interrupted, after which both Bluetooth devices will be paired with
the SAVA 1001. This may take up to two minutes.
4.3

The SAVA 1001 as a receiver (RX)

The SAVA 1001 is a slim and compact Bluetooth audio receiver
that digitally streams hifi audio wirelessly from your smartphone or
tablet to your audio system.
4.3.1

Audio outputs

The audio outputs are only used if the SAVA 1001 is set as a
receiver. If the SAVA 1001 is set as a receiver, it requires an
audio source to receive audio wirelessly. This source may be a
Bluetooth-enabled smartphone, tablet or computer.
4.3.2

Switching on

Slide the TX/Off/RX switch to the RX position.
The blue LED will now start to blink slowly, indicating that the
SAVA 1001 is switched on.
10
© VOGEL'S