Use; Stop; Start; Waiting Mode - JRI Maxant Mini SPY Green Manuel D'utilisation

IV. USE
a)

Stop

When you receive it, your Mini SPY RF GREEN is stopped. Only the time clock is active. It can neither emit nor receive anything.
b)

Start

-
-
c)

Waiting mode

The red led will be on 2'' if you press 5'' on the push button. In this case, the Mini SPY RF GREEN is waiting for programming
d)

Configuration

Mini SPY RF GREEN configuration is done from the Sirius software and then transferred into your Mini SPY RF GREEN by radio frequency.
e)

Measurement start

The Mini SPY RF GREEN has 2 starting mode:

automatic start

manual start

f)
Automatic start
Your Mini SPY RF GREEN starts recording:
automatically when the configuration is transferred,
at a programmed date and time:
g)
Manual start
Press shortly on the pushbutton
h)

Alarm visualisation

The Mini SPY RF GREEN is equipped with different alarm indicators, when a threshold limit is overpassed.
i)

Measurement stop

Depending on the configuration, the Mini SPY RF GREEN can stop recording or not. The different options are:
Rolling memory: once the memory is full, the new values replace the old ones.
©JRI Maxant
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
dd / mm / yy
hh / mm / ss
Alarm LED (red):
Flashes every 15''.
To start your Mini SPY RF GREEN, please press between 5 and 10" on the button:
- the 2 LEDs are on and flash at the same time
all the display segments are also on
Mini SPY RF GREEN is now in waiting mode
Remark: If you press >10'' => no effect => remains off
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
11