Publicité
Les langues disponibles
Les langues disponibles
General Troubleshooting Guide
Symptom
Tool runs slowly
or will not
operate.
Moisture blowing
out of tool
Tool cuts slow or
does not cut
Possible Cause(s)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
1. water in tank
2. water in the air
lines/hoses
1. worn blade
2. wrong blade type
www.campbellhausfeld.com
Corrective Action
1. Flush the tool with Campbell Hausfeld air
tool oil, gum solvent, or an equal mixture of
SAE 10 motor oil and kerosene. If Campbell
Hausfeld oil is not used, lubricate the tool
after cleaning
2. Lubricate the tool according to the lubrication
instructions in this manual
3. Adjust the compressor regulator to 90 psi
maximum while the tool is being triggered
4. Tighten and seal hose fittings if leaks are
found
5 a. Be sure the hose is the proper size. Long
hoses or tools using large volumes of air
may require a hose with an I.D. of 1/2"
or larger depending on the total length of
the hose
5 b. Do not use multiple number of hoses
connected together with quick connect
fittings. This causes additional pressure
drops and reduces the tool power.
1. Drain tank. (See air compressor manual). Oil
tool and run until no water is evident. Oil tool
again and trigger saw
2 a. Install a water separator/filter. NOTE:
Separators only work properly when
the air passing through the separator is
cool. Locate the separator/filter as far as
possible from the compressor
2 b. Install an air dryer
2 c. If the original separator will not separate
all the water from the air, install a
Campbell Hausfeld belt air filter (PA2121)
1. Replace blade
2. Use correct blade type for material being cut.
Fine teeth for metal; coarse teeth for wood
Cl154000AV
7
Publicité
