Campbell Hausfeld CL154000AV Instructions D'utilisation page 5

Blade type
Material Being
Cut
Metal
wood
Chart 2
RemovInG/chanGInG the saw
Blade
1. Disconnect tool from air supply.
2. Use a Phillips head screwdriver to
loosen cover screw (Figure 3).
Figure 3
3. Use a 4 mm hex wrench to loosen set
screws which secure sawblade in tool
(Figures 4 & 5)
Set Screw
Figure 4
Blade Type
Fine Tooth
Coarse Tooth
Cover
www.campbellhausfeld.com
Figure 5
4. Carefully pull blade out of saw body
as shown in Figure 6.
Saw Blade
Figure 6
5. To install new blade, insert blade in
slot in tool, tighten set screws on
each side of blade guides, and screw
cover onto tool.
aIR hose
pull the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.
CL154000AV
Set Screw
Never carry a tool
by the hose or
5