Parrot Sequoia Guide Utilisateur page 18

under its sole responsibility that the product described in this user guide
conforms with technical standards EN300328 (v1.8.1), EN301489-17
(v2.1.1), EN 60950-1:2006/A11:2009/A1: 2010/A12: 2011/A2: 2013 in
accordance with the provisions of the R&TTE Directive 1999/5/EC, the
Low Voltage Directive 2006/95/EC and the RoHS Directive 2011/65/EC.
Declaration of Conformity in Canada
This Class B digital camera complies with Canadian standards ICES-003
and RSS-210.
This device complies with the Industry Canada RSS applicable to license-
exempt radio apparatus. Operation is permitted subject to the following
two conditions:
(1) the device must not produce interference, and (2) the user of the device
must accept any radio interference encountered, even if the interference
is likely to compromise operations.
FCC/IC
To comply with the FCC/IC RF exposure guidelines for transmission
equipment, a distance of at least 20cm must be maintained between
the product antenna and individuals. To remain compliant it is not
recommended to use the product at any distance less than this.
Federal Communications Commission (FCC) Statement
To meet the FCC/IC requirements on exposure to RF for transmission
devices, a distance of at least 20 cm must be maintained between the
product's antenna and people. To ensure compliance, it is recommended
that the device not be used at any shorter distance.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates or uses
or can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1) This device may not cause harmful interference and
32
2) This device must accept any interference received, including interference
that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003 and RSS-
210.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
33