Teesa HYPERCARE T400 Manuel D'utilisation page 12

22
Notes:
• Make sure to fully charge the appliance before first use.
• It takes about 1,5 hours to fully charge the appliance what
provides about 2 hours of run time.
1. Connect one plug of the AC charger to the charging socket
of the appliance; connect the other plug to the power supply
socket.
2. When the appliance is charging, red charging indicator is on.
3. When the appliance is fully charged, green indicator is on.
4. Disconnect the AC charger from the appliance and power
supply socket.
* The appliance may become warm during charging. It is a
normal behavior.
EN
CHARGING STATION
• Use the included charging station to charge the appliance. To
do this, first connect one plug of the AC charger into power
supply socket. Then connect the other plug to the charging
socket of the charging station. Finally, place the appliance
into the charging station.
• When the appliance is fully charged, remove the appliance
from charging station and disconnect the AC charger from
the power supply socket and charging station.
ATTACHING AND REMOVING THE ACCESSORIES
Make sure that the appliance is turned off when attaching or
removing the accessories.
33 mm cutter with adjustable comb
1. Start with placing the lug of the cutter on the lower ridge
of the hair chamber and then push the cutter onto the
appliance until your hear a click.
2. Attach the adjustable comb by sliding it on the cutter from
the top and push downwards.
Owner's manual
CHARGING
Owner's manual
3. Remove the comb by sliding it upwards until it detaches
from the cutter.
4. To remove the cutter hold the appliance in one hand and
with a thumb push its teeth out of the appliance.
44 mm cutter with 4 combs
1. Start with placing the lug of the cutter on the lower ridge
of the hair chamber and then push the cutter onto the
appliance until your hear a click.
2. Slide the upper part of the comb onto the teeth of the cutter
and then push lower part of the comb on the cutter so that
the projection at the bottom of the comb locks in the notch
of the cutter (you will hear a click).
3. Remove the comb by pushing the projection of the comb
upwards.
4. To remove the cutter hold the appliance in one hand and
with a thumb push its teeth out of the appliance.
Detail trimmer
1. Start with placing the lug of the trimmer on the lower ridge
of the hair chamber and then push the trimmer onto the
appliance until your hear a click.
2. To remove the trimmer hold the appliance in one hand and
with a thumb push its teeth out of the appliance.
Nose trimmer head
1. Place the lug of the trimmer on the lower ridge of the hair
chamber and then push the trimmer onto the appliance until
you hear a click.
2. To remove the nose trimmer hold the appliance in one hand
and with a thumb push its teeth out of the appliance.
23
EN