Connecting The Center Speaker To The Subwoofer; Start-Up; Select The Center Signal On The Subwoofer; Technical Data - Loewe Centerspeaker Mode D'emploi

Connection
Connecting the Center speaker to the
subwoofer
One of the two wires of the speaker cable (B) is marked black. Connect these
black marked wires with the black terminal on the subwoofer ( wiring according
to the picture below) and the black terminal (A) on the speaker. Connect the
unmarked wires with the red terminals.
Satellite
speaker
Front
left
Power OUT
R
Surr.
L
R
Front C
L
System connector
Subwoofer
Surround
left
- 14
A
B
Center
Front
right
ON
OFF
Bass Intensity
Min. Max.
Phase
0 180
Line IN
Crossover Frequency
Right Subw. Left
Surr.
Front 50 250.
Right Center Left
230V~50/60Hz
Surround
right
Position the speaker as described on page 11 or mount the speaker at the wall
with the wall holder or on the optional stand as described in the
respective installation instructions. Before beginning with start-up and opera-
tion, make sure that all the cables are connected correctly.

Start-up

Select the center signal on the subwoofer

Switch not pressed = center via satellite speaker.

Technical Data

Dimensions loudspeaker in cm
with wall holder
with table stand
Weight loudspeaker in kg
with wall holder
with table stand
Fitting
Load capacity
Impedance
Transmission range
Sound pressure
W 82,3 x H 9,1 x D 9,1
W 82,3 x H 9,1 x D 10,1
W 82,3 x H 10,9 x D 25,8
2x bass 80 mm, paper diaphragm
2x broadband 80 mm, paper diaphragm
1x treble, coated fabric calotte, Ø 33mm
75W (sine) / 120W (max. music)
4 -8 Ohm
85 Hz–22 kHz ± 3dB
84 dB spl (1w/m)
5,4
6,2
8,6