Important Safety Information - WINK RELAY Guide De L'utilisateur

IMPORTANT SAFETY INFORMATION

Carefully read all safety information before installing.
WARNING: RISK OF ELECTRIC SHOCK
• Before installing, servicing, or removing Relay,
TURN OFF POWER AT CIRCUIT BREAKER.
After power has been turned off, make sure the light
•
switch you are going to replace with Relay is powered
down before continuing installation.
NOTE: It is recommended to use a circuit tester
to make sure the circuit is off.
Installation involves handling high-voltage wires;
•
follow warnings and safety instructions carefully.
IF YOU ARE UNSURE ABOUT ANY OF THE
•
INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN.
CAUTIONS & REQUIREMENTS
• Relay can ONLY connect to a 2.4GHz router
broadcasting with a 20 MHz bandwidth.
• Relay must be installed in accordance with the installation
4
instructions, and installed/or used in accordance with
appropriate electrical codes and regulations.
• Only use this device with copper or copper-clad wires.
• Relay can ONLY be installed in a light load gang box
(a gang box that controls lights only.)
• Relay can only be used in a single or double gang box
where a neutral wire is present. Do not install in a multi-
gang box unit.
• Relay is not compatible with a 3-way light switch.
• Relay replaces single or double light switches not wired
to an AC outlet.
• The included wire stripper has an exposed blade which
could potentially cause injury. Use with caution.
• Use this device only for its intended purpose as
described in this user guide.
5