Watts Vision central Guide D'utilisation page 2

MAIN CHARACTERISTICS
 Touch screen
 Interface via internet (WIFI)
 Wall mountable with power supply 85-265V (50-60)Hz
 Can be placed on the table with supplied bracket and mini
USB power supply (0-5V)sold separately
 Battery operation (only for settings)
 RF Communication with other devices
 Multiple heating/cooling devices control.
 SD Card update
 Intuitive menus for devices management.
Charge the central unit for at least one hour before
pairing the devices already mounted
DEVICES compatible with Watts
Vision Central unit
BT-FR02
RF
BT-WR02
RF /
X
BT-WR02
HC RF
BT-PR02
RF
BT-
M6Z02 X
RF
BT-TH02
X
RF
BT-A02
RF
BT-D02
X
RF
BT-DP02
RF
REPEAT
ER
 50 heating master devices (thermostats) and 50 heating
slave devices (receivers).
 25 ON/OFF devices with weekly program with 15 min steps.
 50 lighting devices (ON/OFF).
 You may have to use a Watts RF repeater if you want to
extend the RF range.
X X X X X
X X X X
X X
X X
X
X X X X
INSTALLATION
a- Wall mounting
1- Connect the power as described below :
NOT TO BE USED
POWER SUPPLY 85-265V - 50/60HZ
2- Screw the power unit on the wall. Be careful ! The tab must
be on the top !
3- Put the switch on ON position
ON/OFF
4- Mount the Central on the power unit and slide it on the
bottom to clip it. The Central is ready for operation.
b- Table installation
CABLE
ON/OFF
Connect the central unit with the cable (5V, 1A) and then mount
the leg support on it and put the switch on ON position. The
central unit is ready for operation.
2