Danby FRESH DFG58D1BSS Manuel Du Propriétaire page 10

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the default door opening on the appliance is
inconvenient, follow the steps below to change the
direction of the door swing.
1. Remove the two screws that secure the hinge
axis to the lower right hinge. Slide the door
outward from the bottom to remove it from the
upper right hinge.
2. Remove the upper right hinge from the cabinet.
3. Remove the screw hole covers from the upper
left side of the cabinet and install the upper left
hinge. Place the screw hole covers in the screw
holes on the upper right side of the cabinet.
4. The lower left hinge is pre-installed on the
cabinet. The lower right hinge does not need to
be removed.
5. To reinstall the door, it must be fl ipped 180°
from its original position. Install the door by
sliding it onto the top hinge pin, then replace
the door axis by placing the hinge pin in the
bottom of the door and securing it to the lower
left hinge.
1. Lower right hinge
2. Axis screws
3. Hinge axis
4. Upper right hinge
5. Hinge screws
6. Upper left hinge
7. Lower left hinge
1
6
7
9
2
3
4
4
5
5
6
2 7
3