Adjusting The Speaker Volume; Monitor Settings; Adjusting The Monitor Angle; Touch Panel Calibration - Sony XAV-W1 Mode D'emploi

1
While the unit is off, touch "SETUP,"
the "Sound" tab, then
The "Speaker Setting" display appears.
The setting of center speaker/subwoofer
connection status made in initial settings
(page 14) are shown.
2
Touch "Center Speaker" or
"Subwoofer," then "ON" or "OFF."
The setting is complete.
To return to the previous display, touch
To close the setup menu, touch "SETUP."
Note
If you set to "Center Speaker ON" without connecting
the center speaker, vocal sound is not output, and if
you set to "Subwoofer ON" without connecting the
subwoofer, bass sound is not output.

Adjusting the speaker volume

You can adjust the volume level of each
connected speaker.
The adjustable speakers are "Front R" (Front
Right), "Front L" (Front Left), "Surround L"
(Rear Left), "Surround R" (Rear Right),
"Center*," and "Subwoofer*."
* Adjustable only when a center speaker is connected
and set to "Center Speaker ON" (page 34), and a
subwoofer is connected and set to "Subwoofer ON"
(page 34).
1
While the unit is off, touch "SETUP,"
the "Sound" tab, then
The "Speaker Setting" display appears.
2
Touch "5.1ch Speaker Level."
The setting display appears.
3
Touch the speaker, then +/– to adjust
the level.
Repeat this step to adjust all speaker volume.
To restore the default setting, touch "All
Reset."
To return to the previous display, touch
To close the setup menu, touch "SETUP."

Monitor Settings

to proceed.

Adjusting the monitor angle

You can adjust the monitor angle for best
viewing.
1
.
2
3
To return to the previous display, touch
To close the setup menu, touch "SETUP."
to proceed.

Touch panel calibration

Touch panel calibration is required if the
touching position does not correspond with the
proper item.
1
2
.
3
To cancel calibration, touch "Cancel."
To close the setup menu, touch "SETUP."
Touch "SETUP," the "System" tab,
then to proceed.
The "Monitor Setting" display appears.
Touch "Monitor Angle."
The setting display appears.
Touch –/+ to adjust the angle.
The adjustment is stored.
The monitor retains the angle even after the
front panel is opened and closed.
Touch "SETUP," the "System" tab,
then to proceed.
The "Monitor Setting" display appears.
Touch "Touch Panel Adjust."
The setting display appears.
Touch the targets in sequence.
The calibration is complete.
.
35