ÉTAPE 3 / STEP 3
I
nstallatIon du PIédestal et des bornes
• Glisser le piédestal sur l'assemblage de mise en
cascade de façon à ce que les borniers soient accessibles
par la porte du piédestal prévue à cette fin, puis visser
les boulons qui fixent le tout à l'ancrage.
• Dévisser et enlever la ou les plaques du haut du piédestal,
selon le nombre de bornes à installer.
• Passer les fils d'alimentation (2 lignes et 1 mise à la
terre) de chacune des bornes dans le trou rectangulaire
jusqu'aux disjoncteurs, en laissant sortir 8 pouces
(20 cm) de fil.
• Procéder au raccordement des fils d'alimentation de
chacune des bornes à leurs disjoncteurs respectifs en
prenant soin de maintenir la répartition balancée (dans le
cas d'une alimentation triphasée), puis installer les bornes
sur le piédestal, tel qu'indiqué dans le guide d'installation
de la borne.
p
edestal and charging station installation
• Slide the pedestal over the assembly, making sure
that the terminal blocks are facing the access door at the
bottom of the pedestal. Tighten the 4 mounting nuts that
secure everything to the anchor.
• Unscrew and remove the plate(s) from the top of the
pedestal, depending on the number of charging stations
to install.
• Pass the power supply wires (2 lines and 2 ground
connector) from each rectangular hole at the top of the
pedestal down to the breakers.
• Connect the wires feeding the charging stations to their
respective breakers, being careful to keep the phases
balanced (in the case of a tri-phase supply) and install
each charging station on the pedestal, as per the
charging station installation guide.
© 2015 ADDÉNERGIE TECHNOLOGIES INC. TOUS DROITS RÉSERVÉS Les informations et les spécifications contenues dans ce document sont sujettes aux changements, modifications et ajouts à n'importe quel moment et sans préavis.
© 2015 ADDÉNERGIE TECHNOLOGIES INC. ALL RIGHTS RESERVED Information and specifications contained in this document are subject to change, amendments and additions at any time, without notice.
:
: