Start Operation; Factory Default Setting - Danby Products Premiere DDRSOAlGP Guide D'utilisation Et Soins De Propriètaire

OPERATING INSTRUCTIONS (cont'd)

START OPERATION

1) Place the product in an upright
position on a flat, stable, ana neat-
resistant surface. Make sure there is
nothin2 flammable or heat sensitive
,oocm
within inches).Onerating
(39
the product in any other position coUld
cause a hazard
2) Insert the plug into a suitable wall
socket. The dehUmidifier is suitable for
on an electricity supply
rating
having tlie same voltage as tliat showm
WATER FULL
When the water tank is full and/or incorrectly positioned inside the cabinet, the water
INDICATOR
full
LIGHT (RED)
correctly re-positioned
This condition will result in the immediate shut down of the dehwnidifving system (both com_pressor and fan
motor erations are terminated).This is a safety feature. When the walerfarik is emptied andlor correctly
re-positioned, the dehumidifier
NOTE: It may take several minutes before operating conditions resume.
BUCKET
FULL LIGHT
• When the water tank is full the machine will stop and the"Bucket Full, light will
illuminate.
• The water tank should be carefully removed from the machine by slid4tg it outward
from the front of the unit, and it shOuld be emptied. When the
properly in the machine, the unit will start up and run normally (¥ig. 2).
NOTE:Please use both hands
FACTORY
DEFAULT SETTING
Humidity Setting:60%
Fan Speed: Low
NOTE:In the event of a power failurehall previous
settings are automatically erasedlcance ed
WATER TANK
ProJJC!: installation of the water tank is crucial in maintaining reliable dehumidifier
OPERATION
on.
switch, controls both the water level and operation of the dehumidification process.
When the water tank. is full and/or accidentally displaced inside the cabinet, the float switch actuator (inside
the breaks contact with the safety switcli.This condition results in the immediate shut down of the
tank)
compressor and fan motor system, preventing moisture from being condensed.
NOTE: Never tamper with or attempt
on rating label.
its
3) Make sure the water tank is correctly
located.
for the first time, if the 'Bucket Full''
L
able to move freely, then return the
water tank
(Fig. 1).
red light on and remains on until such time that the tank is emptied and/or
turns
resume operation automatically.
Will
to
carefully empty the water tank.
Each time the unit is disconnected/re-connected and/or in the event of a power failure,
the electronic circuitboard automatically defaults
your
lf
The water tank holds accumulated condensed water anc;
defeat the
to
switchinon the machine
After
l] :t' t;rer is
the correct position
to
tank: is replaced
eJ!!P.1y
to
prosetting was different from the above (default
setting) it will'be neces
settings. W hen the unit is switched "Off" manually
(using the on/off
keypad)
the last
program
to
water level (safety) float switch system.
factorY
1he following
setting:
re-proyour
to
the unit will always default
setting that was used
!>Y
means of a safety