Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Winemaster C50S(SR) USER MANUAL
3.4. DEFROSTING
3.5. VIBRATION ELIMINATION
The vibration of the compressor is controlled in two ways:
The compressor sits on flexible rubber blocks (silent blocks).
The Winemaster is surrounded in its frame by these silent blocks.
Please note: In wooden frame cellars it is very important to store the wine bottles on shelves standing on the
floor of the cellar, NOT on shelves fixed to the walls.
3.6. SECURITY
The compressor is equipped with a safety thermostat which detects any irregular increases in the compressor
temperature. In the case of a dangerous temperature, the compressor automatically shuts down. In the event of
poor ventilation where the air inside the cellar becomes too warm, the C50-S automatically speeds up the
ventilation and heat exchange system to obtain the desired temperature and air circulation.
4. ELECTRONIC CONTROL PANEL
The WINEMASTER is equipped with an electronic thermostat placed on the front of the unit which permits you to view
the mode of operation inside the cellar at any time from the exterior of the cellar. In addition, the thermostat continues
to display the precise temperature inside of the cellar.
The on/off button IOII (reference 2 in diagram) allows you to start the air conditioner and select the level of
ventilation within the cellar.
The button IO (reference 3) when lit up in green indicates the electricity connection of the unit and allows you to
illuminate the integrated flourescent lamp.
The electronic thermostat precisely displays the temperature as well as the current mode of operation within the
cellar. The symbols on the upper left corner of the control panel (reference 4) indicate the WINEMASTER's
current mode of operation: defrost
The thermostat is equipped with a keypad on upper the right side (reference 1) which allows you to change the
temperature setting or manully activate the defrost mode. In order to modify the temperature setting, press the left
arrow button 5 for 5 seconds. The screen (reference 5) should then display the word SET. Again, press briefly on
the arrow button 5. The temperature is then displayed. To increase the temperature setting, press the upward
arrow button
. To decrease the temperature setting, press the downward arrow button
After the modification of the temperature settings, there is an automatic delay before the compressor restarts
itself. This is an integrated trouble shooting system which prevents frequent stopping and starting to prolong the
life of the compressor.
The WINEMASTER C50-S/(SR) defrosts automatically by shutting down the compressor for 7
minutes each hour.
4
5
12
, heating
1
5
2
II
O
I
3
I
0
, or cooling
.
Page 15
May 2003
.
Publicité
Table des Matières
