HK Audio elements E 110 Sub A Mode D'emploi page 9

8 Mains Input
Connect this connector socket using a low-power connection cable
(included with delivery) with the mains socket.
Note: The active elements include a lockable V-Lock mains input
socket. Combined with a lockable connection cable ( „Volex" or
structurally identical, optional available) the power cable can be cut
off thus preventing any risk of inadvertent reactivation.
9 Power switch
When switching on, the signal LED lights up for around 5 seconds in red
and then switches to green to indicate it is ready for operation. The fan
is temperature-controlled and runs throughout the system check.
10 Auto Stand-by (only E 110 Sub AS)
The E 110 Sub AS also includes an auto standby function, which is
switched on and off via an auto standby switch. When switched to ON,
the output stage will automatically revert to sleep mode if no signal
is connected for 180 minutes. From a level of -68 dB (1 kHz), the
E 110 Sub AS resumes operation. Auto standby to OFF deactivates this
function and the subwoofer remains permanently ON.
4 Accessories
EF 45 Base
The foot acts as the base for the top speakers, the amp module or
the spacer stem. The extendable base extensions ensure the attached
elements remain safely and securely in place.
• Stable foot with minimal footprint
• built-in E-connect-signal connection
• 2x parallel NL4 connection
• 7.7 kg
• available as option: The perfect bag for the EF 45
foot , which you can carry over your shoulder.
EF 45 for transportation EF 45 in use
12,5 cm
41 cm
46 cm
EP 1/EP 2 Speaker Poles
In confined spaces, these devices facilitate easy and swift installation.
They are infinitely variable and via E-connect, provide cable-free signal
feed for the attached top speakers.
• Anodized aluminum with large mounting screw
• Built-in E-connect-signal connection
• Weight EP 1: 0.8 kg; EP 2: 0.5 kg
EP 1
0,94 m
min. 0,86 m
max. 1,52 m
EP 2
0,45 m
min. 0,37 m
max. 0,54 m
Soft Bag (E 435, E 835, EA 600)
The padded case can accommodate four E 435 or two E 835 mid/high
elements or four EA 600 amp elements. In addition, a spacer stem can
also be fitted.
Subwoofer Cover
Subwoofers are frequently not moved around with kid gloves. With this
in mind, this cover was double-cushioned to effectively protect active
and passive subs against damage in transit.
Also available for ELEMENTS' permanent installation:
Install Kit E 435 • Install Kit E 435 A (active)
The ELEMENTS Install Kit consists of E 435 and EA 600
units that have been modified for wall mounting. Up to
six components may be combined. The elements can be
positioned horizontally through 180 degrees on the mounting
brackets and be fixed swiftly and hassle-free using the two
socket head screws provided.
Use speaker cords equipped with mono ¼" (6.3 mm) jack
plugs. Visit www.hkaudio.com to learn more about this.
Elements 2.0
9