1. The test of dropping steel ball and waterproof, dust-proof protection was created
under controlled laboratory conditions to ensure the accuracy of the results,
which comply with MIL-STD-810G/ Method 516.6/Procedure IV military standards
and IP67 IEC 60529 standard. In the daily life, the Permanent of protection might
be reduced due to the abrasion, but anti-splash, waterproof, dust-proof will last
forever. Fall protection does not mean 100% no damage in any condition. Please
do not charge the tablet in wet condition. Never do the dropping ball, waterproof
etc,. test under the uncontrolled laboratory conditions. The damage from dunked,
drop shock will be out of our warranty.
2. Highest brightness of LED backlight will appear obvious fever, battery life
shortened, please adjust the brightness according to the actual use environment.
3. Do not use or store the machine in a too cold or hot place because high
temperature shortens the life of electronic parts and destroys batteries, makes
some plastic parts deformed or melting. Using in cold environment, be sure to
tighten the interface seal cover to avoid the formation of cold air into the
condensation, when the temperature increases, the device will form moisture,
affecting product life.
4. Never let this product be changed in humid, inflammable and explosive
environment.
5. There is lithium polymer battery built-in ,some tips to avoid damage and increase
battery life: If the device is going to be idle, ensure that the power of battery is
not less than 80%,a full charge and discharge once every month is necessary; In
cold areas, if the power is less than 30%,please charge the battery in time; Using
after a long term storage, please pay attention to the ambient temperature. Do
not charge the battery under -10 °C or higher than 50 °C. The battery is not only
safe, but also is long-life, battery(it usually takes 4-8 hours to be full charged,
which depends on the capacity of battery), but never charge the battery
continuously for a long time.
6. Some hand straps of equipment have antenna, external components etc inside,
for dismantling, be sure to check and confirm whether there are parts connected.
7. Do not try to disassemble the equipment, the disposal from nonprofessional or
technical people may cause damage.
8. Do not use strong chemicals, cleaning agents or strong detergents to clean the
equipment, if necessary ,please use alcohol or electronic cleaning agent instead.
AIR³ Quick User Guide
Further notice
13