Power Supply Unit Leds Information; Speed Setting Button Information - Fiam eTensil Manuel D'utilisation Et De Maintenance

POWER SUPPLY UNIT LEDS INFORMATION

Colour Led
Led 1 Green
Led 2 Red
Led 3 Red
Led 4 Green
Led H Green
Led L Green
Led S1 Yellow
Led S2 Yellow
Led S3 Yellow

SPEED SETTING BUTTON INFORMATION

Press this button to change from H (high speed) to L (low speed) and vice versa.
The tightening/untightening speeds can be set independently: to set the tightening
speed, set the tool to tightening and press the power supply unit button; to set the
untightening speed set the tool to untightening and press the button.
44
Clutch triggered, the tool has reached the set torque
Motor stalled or PTS released (Lever start + Push-to-start) in start mode
LEVER +PTS (Lever start + Push-to-start) or BUTTON +PTS mode (Lever
start + Push-to-start)
External stop tool command (only on TPU 2 model, equipped with inputs/
outputs)
On light button
High tool speed
Low tool speed
Emergency input active (only on TPU 2 model, equipped with inputs/outputs)
Tool connected and ready for use
Tool rotating (RUN)
Function description