Petique ST01 Manuel D'instructions page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Assembly
3) Position the Rear Wheel Frame over the
stroller rear leg tubes so that the hole in
the housing lines up and will slide into the
legs. Firmly push down until the Rear Wheel
Frame locks securely into place (Fig. 3).
Make sure the brakes are facing outward.
NOTE: pull on the Rear Wheel assembly to
ensure that it is securely attached to the
stroller.
NEVER use the stroller if the wheels are not locked into place, contact our
customer service department immediately at 800-421-1902, between the hours of
8:30am and 5:00pm PST, for assistance.
TRAY
WARNING:
Do not place hot liquids or more than 3 pounds in the
tray. Serious scalds or unstable conditions could result.
4) To attach the tray, line up the tray slots with
corresponding slots on the stroller frame and
slide down until locked into place (Fig. 4).
NOTE: Check to make sure the tray is
secure before using.
BRAKES
WARNING:
Always set brakes when the stroller is not being pushed
so that the stroller will not roll away. NEVER leave stroller unattended on a
hill or incline as the stroller may slide down the hill.
| 5 |
Copyright © 2017, Petique, Inc., All Rights Reserved.
Stroller Manuals.indd 7-8
5) REAR WHEELS BRAKE: To engage
brakes, apply light downward pressure to the
brake lever bar located on the bottom back
of the stroller. The stroller may require slight
forward or rearward movement in order to
line up the teeth on the brake with each
wheel brake cluster (Fig. 5a).
NOTE: Check that the stroller will not move
and that both brakes are properly applied.
Fig. 3
To release, gently lift up on the brake lever
bar.
FRONT WHEEL ROTATION: To stop the
front wheel from rotating, apply light upward
pressure to the lever located on the front of
the stroller (Fig. 5b).
To release, gently press down on the lever.
SEAT
6) To close the seat, fully open the canopy
(Fig. 6a).
Zip the two zippers of the front mesh window
to the opposite ends (Fig. 6b).
To open the seat, fully unzip both zippers of
Fig. 4
the front mesh window to the opposite ends
(Fig. 6b).
NOTE: DO NOT stroll without all zippers
closed.
Assembly
Fig. 5a
Fig. 5b
Fig. 6a
Stroller Front View
Zip Open
Zip Close
Zip Close
Zip Open
Fig. 6b
| 6 |
Copyright © 2017, Petique, Inc., All Rights Reserved.
7/19/17 12:45 PM

Publicité

Table des Matières
loading

Table des Matières