Power Off Timer Function; Use Of The Battery; Battery Recharge; Life Time Of The Rechargeable Battery - Sammic PCS Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
1) Automatically: when the scale is powered only by battery and the battery is low the backlight is
turned off.
2) Manually: It can be performed by pressing the
Note: Using the backlight and only powering the scale with the battery, the charge of the battery will
last less hours

POWER OFF TIMER FUNCTION

This function is permanently enabled when the scale is on, and only when you do not have the
AC/DC power supply connected to the scale. When the scale is not use for a period of time greater
then 15 minutes, it will be automatically turn off and therefore all the information of the transaction
you were doing will be lost. To turn on the scale again, just press the
customers operations. The power off timer function permit you to save electricity and avoids
constant battery recharges.

USE OF THE BATTERY

As mentioned before, the scale can operate with a 6 volt built in battery or with an AC/DC power
supply. The battery is rechargeable using the AC/DC power supply.

BATTERY RECHARGE

To make this operation, just connect the AC/DC power supply to the scale for 10 HOURS making
sure that the scale was turned off. The energy stored in the battery during a recharge can last up to
30 hours of continuous operation. When you recharge the battery for some hours, but the battery
can not get enough charge to turn on the scale, then you must have to charge the battery, in this
case contact to your authorized distributor.

LIFE TIME OF THE RECHARGEABLE BATTERY

The charging capacity of the rechargeable battery in this scale decreases according to the number of
charge/discharge cycles, this causes the service life is reduced to 1000 cycles. For this reason the
warranty period of the battery is limited to six months after the purchase date of the scale.

LOW BATTERY INDICATOR

If the battery does not have enough energy to keep the scale operating a long time, appears "LO
bAt" in the "WEIGHT" indicators and "PRICE" indicators, the scale stops itself and does not respond
to the instructions until the battery be recharged or be connected to the AC main.
12
ENGLISH
Service life in relation to charge/discharge cycles
SERVICE LIFE IN RELATION TO CHARGE/DISCHARGE C
% of capacity
% OF CAPACITY
available
AVAILABLE
100
80
40
200
key.
400
600
800
1000
Charge and discharge cycles
CHARGE AND DISCHARGE CYCLES
key, and repeat your
1200

Publicité

Table des Matières
loading

Table des Matières