PCM KSE2507-KAI-2X Mode D'emploi page 2

English
1. Before fixing the tool holder on the
machine, introduce the M6x6 screw
in one of the two internal threads [2]
provided for this purpose in order to plug
the unused coolant inlet.
2. Introduce the plug
position of the turret.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSE2507-KAI-2X
[1]
2
1
on the empty
[3]
4 5
3
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
RBT
Validation : 17.05.2019
3. Introduce the tool holder on the machine
using the shank
[4]
positioning.
4. Tighten the 3 M8x110 screws
Important: make sure that the screws
have the same clamping force.
7
5. During the mounting or the dismounting
of your cutting tools, block the broach on
flats planned for that purpose.
[7]
6. The tool shank diameter should never
have a difference of more than 0.4 mm
from the diameter of the clamping collet.
Example: clamping collet diameter 9.5
mm => Shank
minimum.
MARK : Never use the tool holder with
empty positions.
protection plug.
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
email:
Document :
KSE2507-KAI-2x
Mode d'emploi
Page : 2 de 4
and the pin for
[5]
.
[6]
6
diameter 9.1 mm
Use the supplied
http://www.pcm.ch
office@pcm.ch