Sonicare elite e7000 Mode D'emploi page 8

EngliSh
8
Features
Easy-start
- This Sonicare model comes with the Easy-start feature activated, which
helps you get used to brushing with the Sonicare.
- The brushing power gently increases to full power over the first 14
brushings.
- The Easy-start feature is active if you hear 2 beeps immediately after
you switch on the Sonicare. Once the Sonicare has reached optimal
brushing power (after the 14th brushing), you no longer hear the 2
beeps at the beginning of each brushing cycle.
Note: Each of the first 14 brushings must be at least 1 minute long to move
properly through the Easy-start ramp-up cycle.
Note: While the Easy-start feature is activated, the Dual Speed feature
(Gentle and Max speed modes) does not function. To use the Dual Speed
feature immediately, deactivate the Easy-start feature.
Deactivating or activating the Easy-start feature
1 Attach the brush head to the handle.
 Place the handle in the plugged-in charger.
3 To deactivate the Easy-start feature, press and hold the on/off button
for 5 seconds. You hear 1 beep to indicate that the Easy-start feature
has been deactivated.
4 To activate the Easy-start feature, press and hold the on/off button
for 5 seconds. You hear 2 beeps to indicate that the Easy-start
feature has been activated.
Use of the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces the effectiveness of the Sonicare toothbrush
in removing plaque.
Make sure the Easy-start feature is deactivated and the handle fully
charged when the Sonicare is used in clinical trials.
Smartimer
- This Sonicare model comes with the Smartimer feature, which
automatically sets the brushing time to the 2 minutes that dentists and
dental hygienists recommend.
- After 2 minutes, the Smartimer automatically switches off the
toothbrush.
- If you want to stop brushing briefly during a 2-minute brushing cycle,
press the on/off button. When you press the on/off button again, the
Smartimer resumes the brushing cycle at the point where you stopped.
- The Smartimer automatically resets to the beginning of a 2-minute
cycle if:
- you stop brushing for 30 seconds or longer;
- you put the handle in the charger.