Classic Phono TCD-2600 Mode D'emploi page 7

NOTE: THIS UNIT NOT ONLY PLAYS COMMERCIAL COMPACT DISCS BUT ALSO SELF-COMPILED CD-RW
DISCS.
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all commercial CDs. They will also
read self-compiled CD-R/CD-RW discs but it may take up to 10 seconds for playback to start. If playback
does not start, it is likely due to the quality of the CD-R/RW disc and/or the compatibility of the CD
compilation software. Manufacturer is not responsible for the playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
PLAYING A CD
1. Rotate the POWER/VOLUME ON/OFF SWITCH (5) to turn on the TCD-2600.
2. Rotate the FUNCTION SELECTOR (2) to select CD mode.
3. Press CD DOOR OPEN/CLOSE BUTTON (8) to open the disc tray.
4. Carefully place an audio CD with its label side upward on the tray.
5. Press CD DOOR OPEN/CLOSE BUTTON (8) to close the tray, the disc will started playing the first track
once loaded.
6. To pause playback, press the PLAY/PAUSE BUTTON (7). To resume playing press PLAY/PAUSE BUTTON
(7) again.
7. You can choose to play your favorite track directly by pressing either the F. SKIP BUTTON (16) or B.
SKIP BUTTON (14). The LED DISPLAY (11) will indicate the correct track number selected.
8. To locate a particular section within a track, press and hold the F. SKIP BUTTON (16) or B. SKIP
BUTTON (14) until the section is found. Release the button to continue playing your selection.
9. To stop playing, press STOP BUTTON (9).
10. When you wish to turn off the CD Player, rotate the POWER/VOLUME ON/OFF SWITCH (5) to the OFF
position
REPEAT MODE
REPEAT 1
When the FOLDER/REPEAT BUTTON (6) is pressed once, the REPEAT ONE SONG INDICATOR (18) on the
LED DISPLAY (11) will be lit steadily. The current track will be played repeatedly.
REPEAT ALL
When the FOLDER/REPEAT BUTTON (6) is pressed third time, the REPEAT ALL INDICATOR(19) on the LED
DISPLAY (11) will be lit steadily. The whole disc will be played repeatedly.
CD PROGRAM PLAY MODE
This function allows the CD tracks to be played in programmed sequence.
NOTE: Program can only be set in STOP mode.
1. Load the CD Disc you wish to program.
CD OPERATION
7