Black Max BM151333 Manuel D'utilisation page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
NOTE: All water inlets are covered by a plastic cap that
must be removed before installing hoses onto the pressure
washer.
INSTALLING THE DETERGENT TANK AND
HOLDER
See Figure 4.
Position the groove on the detergent tank holder over the
rib on the side of the pressure washer. Push down on the
holder until it locks into place.
To install the detergent tank, place the tank in the holder and
place the cap and tube onto the tank. Push the cap over the
neck of the tank and make certain it is installed securely.
INSTALLING WAND STORAGE BRACKET
See Figure 5.
 Slide the wand storage bracket over the tab on the unit
until it is securely seated.
 Place the trigger handle and the spray wand into the
grooves in the storage bracket when not in use.
INSTALLING/REMOVING SPRAY WANDS
See Figure 6.
There are two spray wands included with the pressure washer.
The variable fan spray wand produces a flat spray and has
a low-to-high pressure adjustment. The turbo spray wand
produces a pencil jet spray for higher intensity cleaning.
ASSEMBLY
To install spray wand:
 Push the spray wand into the trigger handle and rotate
clockwise to secure.
 Pull on the spray wand to be certain it is properly
secured.
To remove spray wand:
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
 Push in on the spray wand and rotate counterclockwise
to remove.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 7.
 Remove the protector cap from the water inlet on the
trigger handle.
 Insert the nut end of the high pressure hose over the
water inlet on the trigger handle and rotate clockwise
to secure. Hand tighten, then use wrench provided to
securely tighten.
 Pull on the hose to be certain it is properly secured.
CONNECTING HIGH PRESSURE EXTENSION
HOSE TO HOSE REEL
See Figure 8.
 Place the L-shaped coupler end of the extension
hose over the water outlet on the front of the pressure
washer.
 Securely tighten the collar.
 Place the other end of the extension hose over the water
inlet on the hose reel.
 Securely tighten the collar.
 Pull on each hose connection to be certain it is properly
secured.
Page 10 — English

Publicité

Table des Matières
loading

Table des Matières