Power Supply - ANT BHS Série Mode D'emploi

14 SIDE RECESSED HANDLE - SUBWOOFER
Use these handles (Fig.1) for transporting and positioning the subwoofer. Do not
use them to fly the subwoofer or to lock it in any position.
15 REAR RECESSED HANDLES - SPEAKERS
Use this handle to transport and position the system satellites. Do not use them
to fly the speakers on the wall, the ceiling or to lock in any position the satellites.
Fig.1 - Transport handles - Subwoofer
Fig.2 - Transport handles - Satellite speaker
15
BHS Series
10 User manual |
14

3.2 | POWER SUPPLY

1
2
1 MAINS INPUT
IEC mains socket with integrated EMI filter. Each package is supplied
with the necessary power cord, specific for your area. Insert the mains
cable into this socket, but make sure the system is switched off before
connecting the cable to the mains. For your safety, never disconnect the
ground lead.
WARNING!
Never remove the front protection grille. To prevent the risk of electric
shock, in case of accidental damage or replacement of the protection
grille (to be carried out by service centers only), immediately disconnect
the power supply.
CAUTION: To reduce the risk of electric shock, never connect the power
supply to the appliance while the grille is removed.
2 FUSE
Protection fuse integrated in mains socket.
CAUTION: Replace the fuse only with one of the same type and with the
same value.
If the fuse blows repeatedly, contact an authorized service center.
3 POWER ON/OFF
Use this switch to turn ON/OFF the system.
NOTE: For proper operation always switch on the system last and switch
it off first. Before turning on the system, make sure the MAIN LEVEL knob
is at minimum.
3
BHS Series
11
| User manual