Tetenal COLORTEC C-41 Mode D'emploi page 5

ALTERNATIVE DEVELOPMENT AT 30 °C
Processing should be done at 30 °C if standard development at 38 °C produces uneven
results.
Step
0 Pre-heat the
developer drum
1 Colour Developer
2 Bleach Fix
3 Rinse
4 Stabilizer
NOTES ON PROCESSING STEPS:
Rinse with flowing water. Change water every 30 seconds or rinse for longer periods.

RAPID DEVELOPMENT AT 45 °C (ONE-SHOT DEVELOPMENT)
Step
0 Pre-heat the developer drum
1 Colour Developer
2 Bleach Fix
3 Rinse
4 Stabilizer
NOTES ON PROCESSING STEPS:
Depending on the processor used, the rotation speed and the type of film, the time for

the colour developer is to be lengthened in the case of under-development (+ 10 s) and
shortened in the case of over-development (- 10 s).
PUSH-DEVELOPMENT AT 38 °C
Colour Developer time for each f-stop step is to be extended by 30 seconds at 38 °C.
Temp. °C
500 ml
1.000 ml
30 ± 0.5
30 ± 0.5
30 ± 3.0
30 - 40
20 - 40
Processing time
films films
1 - 2 3 - 4
1 - 4 5 - 8
5' 00''
8' 00'' 9' 00''
6' 00'' 8' 00''
Temp. °C
45 °C
45 °C
45 °C
45 °C
20-40 °C
films films
5 - 6 7 - 8
9 - 12 13 - 16
10' 00'' 11' 00''
12' 00'' 20' 00''
6' 00''
1' 00''
Processing time
2' 00''
2' 00''
3' 30''
4 x 15''
0' 30''
5