Luisi Air FONDI SLTR75 Instructions D'utilisation page 6

Activate the glass panel lifting up, as shown in
the 'Working' section; when the panel is comple-
tely open, which is done by setting the IV speed,
remove the grid as shown in (fig. 8), then remove
the grease filters and make sure the hood is se-
curely fixed to the wall, by using the inside screws
(fig. 9).
Reinsert the grease filters, the grid and close the
front panel by setting the OFF function, as shown
in the 'Working' section.
In External motor version:
Connect the external motor's cable to the terminal
board found inside the plastic box of the wiring .
Make sure to respect the colors of cables when
performing the electrical connection (fig.11).
Sucking version – upper outlet
Fix the pipe bearing bracket to the wall and/or
ceiling by using the anchor screws and screws
provided (fig. 12), centred to the hood.
Connect the motor air-outlet flange to the exhaust
hole, by using a suitable pipe.
Place the two ornamental pipes on the hood
body; lift the internal pipe up until it reaches the
ceiling; then fix it to the pipe bearing bracket, by
using the two self-threaded screws provided.
Sucking version - back outlet
Install the air outlet grill above the hood in the
relative seat (refer to Fig. 13). The stainless steel
chimneys are not necessary.
Filtering version
Install the air outlet grill above the hood in the
relative seat (refer to Fig. 13). The stainless steel
chimneys are not necessary.
In case that the appliance is used in the filtering
version mode, it is necessary to install the char-
coal filters. First remove the metal grease-filter,
as indicated for each model in the MAINTENAN-
CE part, then place the charcoal filter in his seat
just behind the grease-filter.
WORKING
SLTR Model (fig. 14)
The rotary knob (fig. 14A) allows you to select the
various functions of the appliance.
All the indicators (fig. 14B) are always lit in the
stand-by function ; functions are selected sequen-
tially by turning the knob ; the desired function is
set by pressing the knob.
- LIGHTS Indicator (fig. 14C)
This function allows you to switch the lights on or
off; turn the rotary control until the function is se-
lected, then set it by pressing the rotary control.
- Timer Indicator (fig. 14D)
By setting this control, at any speed, the appliance
will be switched off after 10 minutes.
It is necessary to select the control again in order
to exit from this function. . When the. Timer fun-
ction is set , the Timer indicator will flash and the
corresponding speed indicator is lit.
- Speed Indicators (fig. 14E)
They are lit accordingly to the speed set.
OFF Indicator (Fig.15 F): This function allows you
to completely switch off the motor; it is totally lit
during selection and setting, while it is in stand-by
afterwards.
The SLTR75, model, in addition to the4working
features described in the paragraph4above, has
an automatic opening and closing4system of the
glass panel.
The opening of the glass panel corresponds to
and varies according to the motor speed set.
The panel is closed automatically, after the motor
is switched off.
A safety device reverses the panel direction in
case of impact with unusual surfaces during its
normal travel.
All of the appliances are equipped with an elec-
tronic device allowing for automatic switching off
after four hour working from the last operation
performed.
The electric red button on the upper side of the
hood allows to reset the appliance when there is
an operation anomaly.
Press the red button to power off the hood and then
press again the red button to restore power on.
6