Beem Startherm Mode D'emploi page 14

10 EN
Intended use
This appliance is only intended to be used for
toasting, baking, grilling and defrosting food
in the household or similar, non-commercial
establishments such as staff kitchens in
shops, cafés, offices or other business sur-
roundings; agricultural establishments; use
by guests in hotels, motels or other residen-
tial facilities; bed and breakfast establish-
ments.
Any use other than previously stated is consi-
dered as improper use.
WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Adhere to the procedures described in
this user manual.
No claims of any kind will be accepted for da-
mage resulting from use of the appliance for
other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the setup location
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a firm, dry, flat
‹
waterproof and heatproof surface.
Do not place the appliance in a hot, wet
‹
or very humid environment or in the vicinity of
inflammable materials. There must be a gap
of at least 15 cm between the appliance and
any walls, furniture or other objects.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
Never place the appliance or parts of the
‹
appliance in the vicinity of strong heat sour-
ces and hot surfaces (e.g., heating, oven,
grill).
The mains socket must be easily ac-
‹
cessible and allow fast disconnection in the
event of an emergency.
BEEM - Elements of Lifestyle
Do not lay tablecloths, cloths or serviettes
‹
under the feet of the appliance, the appliance
could slide away.
The appliance may not be used or stored
‹
outdoors.
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. The data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undama-
‹
ged and is not laid over sharp edges.
The mains cable must not be pulled tight-
‹
ly, bent, crushed or knotted or come into con-
tact with hot surfaces.
If the appliance is to be connected to the
‹
power supply via an extension lead, the cable
cross-section must be at least 1.5 mm².
The electrical safety of the appliance
‹
is only assured when it is connected to a
properly installed protective earth (PE) con-
ductor system. Connection to a mains socket
without PE conductor is forbidden. If in doubt,
the electrical system must be checked by a
qualified electrician. The manufacturer assu-
mes no liability for injury or damage caused
by a missing or interrupted protective earth
conductor.
Route the mains cable to prevent risk of
‹
tripping.
Symbols used
DANGER
This indicates an imminent hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.