Publicité
Unpacking and
Checking Contents
Separate all parts from the packing materials
and check them against the illustration and
the "Table of Parts." Make sure all parts are
accounted for before discarding any of the
packing material.
Figure 1
L
A
C
K
D
E
F
I
J
H
TABLE OF PARTS
ITEM
DESCRIPTION
A
Guide Bar/Spring Assembly
B
Cross Guide/Chuck Assembly 1
C
Thumb Screw
D
Depth Stop
E
Bar Holder
F
Base Plate
G
Handle
H
Nut
I
Supports
J
Hex Screw
K
Springs
L
Caps
M
Chuck Key
Introduction
Precision hole drilling and countersinking is a
skill that ordinarily takes years to acquire. Yet
the success of many projects depends on
drilling straight, accurate holes.
Your wolfcraft Drill Guide, when used with
your power drill, makes it easy to perform
many precision operations, including straight
and angled drilling, edge and round stock
L
drilling, countersinking and edge sanding. It
provides you with better control for a better
A
finished result.
You can use your wolfcraft Drill Guide any-
where you need a drill—even in masonry or
concrete using the proper bit.
B
Assembling Your Drill
Guide
M
(See Figure 1)
K
Guide as well as your drill owner's manual
E
before attempting to assemble and operate this
product.
1. Secure handle (G) to base plate (F) with nut
G
I
2. Remove springs (K) from both guide bars
J
FIG 1
QTY.
3. Thread thumb screw (C) into cross
2
4. Slide depth stop (D) onto guide bar under
1
1
2
5. Place bar holders (E) on guide bars. Rotate
1
1
6. Install hex screw (J) through each support
1
2
2
2
2
1
3
You must read and understand
WARNING
all the instructions of your Drill
(H). The ribs in base plate will hold nut in
position while tightening handle.
(A). Slide guide bars into cross guide/chuck
assembly (B). Position springs back on
guide bars.
guide/chuck assembly.
thumb screw in cross bar/chuck assembly.
Position thumb screw on depth stop facing out.
bar holders so index marks are facing out.
(I). Position guide bars on base plate with
tabs on bar holders passing through slots in
base plate. Hold guide bars vertical and
install supports. Rotate caps (L) clockwise
on top of guide bars to tighten screws.
Publicité
