König HAV-TRHP20KN Mode D'emploi page 4

Step 6:
Before using the headphones, the batteries need to be charged. Take the charging cable with the
2.5 mm power jack and plug it into the recharging socket of the right shell of the headphones.
Note: Leave the headphones to charge for 24 hours before first use. Second and subsequent
charges take about 10 hours.
The red charge LED will light up indicating that charging is in progress.
Operation:
Switch on the audio providing appliance and adjust its volume to roughly a quarter of the maximum
setting. The transmitter will switch on automatically. When the audio appliance is switched off the
transmitter will automatically switch off after 4~5 minutes.
Note: If the volume output is too low the transmitter will switch off or switch to standby mode and
the SIGNAL/POWER LED will not light up. It is not possible to charge and listen at the same time.
Charging has priority.
Step 1:
Switch on the headphones and the POWER LED
will light up.
Do not turn the volume
to maximum when
switching on the
headphones.
4